Methods of ceiling marble cladding

Marble ceiling cladding gives the architecture feeling of marble masses, the building appear as a piece of marble. However there are several types to install marble at ceilings, each method has advantages and disadvantages. Through this article we will discuss ceiling cladding methods,then you can make a decision about which method to use.

There are three methods of installing marble at ceilings. A method before casting the slab and two methods after casting the slab, one of them is using mechanical system. We will discuss the mechanical way of installing in another topic.

Before casting slab method

it’s the most common and simplest way of installing. Where marble place on the wooden framework, and it installs a steel inside the marble. Marble adhesive used to connect marble tiles together. This method sounds easy but it doesn’t reach a good result because it may move during concrete casting. Tiles could move, then it is recommended to put a mortar over the marble to enhance the bond and to protect marble adhesive from ruin by sun rays.

A problem facing this method, frameworks surface is hard to get it leveled, and any defect will appear clearly. Solving this problem can be either by chamfer the tiles edges, then it’s hard to notice its not level. Another alternative is to adopt the wood frame level, either by putting an over layer plywood to re-level the surface. For professional it’s recommended to make cladding surface lower than the rest of the slab by 5 cm. Then put sand into this area and arrange marble tiles as its verse tiling, then you can control the level precisely. 

marble cladding for ceilings methods
During working at marble cladding for ceiling, and before installing it rips blocks and steel bars. Gaza 2018
This craftsman, install Travertine tiles for ceiling cladding, using before casting method. He uses small marble pieces to gather tiles at same level by marble adhesive. Gaza, ORIGIN DESIGN, 2019
marble cladding for ceilings defects
marble cladding for ceilings defects, Gaza 2018

After casting slab – by casting method

This method has a better quality than the previous method, but it is not suitable for a large area. By making a new framework underneath the slab and by leaving the thickness of the marble and a space for cement mortar. Then steel wire will connect to the marble tile, after that arrange marble at the framework. Then connecting the marble wires to a steel mesh connecting to the concrete slab, and then it’s ready for concrete casting. We need to cast the concrete from the top, this by opening a 10 cm open at the concrete slab. But be aware to add more water to the concrete and extra cement to have a good concrete suitable for this job. It’s better to open several openings for casting at the slab. Because we need concrete to reach the top and air will get out through them.

After Casting method, Gaza 2018

As much as marble has a brilliant appearance at ceiling but also installing it is not an easy job, and it’s hard to fix and defects after installing. 

Leave a Reply

Your email address will not be published. Required fields are marked *